Fcc Compliance Statement - Medion LIFETAB E10311 Mode D'emploi

Types of Pixel Failures:
• Type 1:
A constantly lit pixel (a bright, white spot), even though it is not addressed. A
white pixel is caused when all three sub-pixels are lit.
• Type 2:
A pixel that does not light up (dark, black spot), although it is addressed
• Type 3:
Abnormal or defective red, green or blue sub-pixels. (E.g. constantly lit with half
the brightness, one colour is not shining, blinking or flickering, but not
belonging to Type 1 or 2 Pixel Failures).
In addition: A cluster of type 3 (= 2 or more defective sub-pixels in an array of 5 x 5
pixel). A cluster is an array of 5 x 5 pixel (15 x 5 sub-pixel).
EN 9241-307, Class II
Resolution
1024 x 768
1280 x 800
1280 x 854
1280 x 1024
1366 x 768
1400 x 1050
21.1.

FCC Compliance Statement

This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of FCC Rules. These limits are designed to pro-
vide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interfer-
ence to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful in-
terference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced technician for help.
Changes or modifications not expressly approved by the party responsible for com-
pliance could void the user's authority to operate the equipment. Shielded interface
cables, if any, must be used in order to comply with the emission limits.
34 of 36
Type 1 Type 2
2 2
3 3
3 3
3 3
3 3
3 3
Cluster
Type 3
Type 1, Type
2
4 0
6 0
6 0
7 0
7 0
8 0
Cluster
Type 3
2
3
3
3
3
3