Scope Of Delivery; Technical Data; Introduction; Recommended Applications - Storch HotKnife 250 Mode D'emploi

Scope of delivery

One blade each of 200 mm and 250 length, cutting guide incl. stop, profile cutting car-
riage with two flexible 300 mm blades for cutting u-profiles and embossments, Allen
key for fitting blades, in a storage and transport case.

Technical data

Voltage: 230 Volts / 50 Hz
Rating: 190 Watts
Operation: 15s permissible switch-on period / 45s required switch-off period
Weight: 300 g
Length: 260 mm
Width: 50 mm
Temperature: 316° C
Cutting depth: 200 mm or 250 mm

Introduction

Note:
Before operating the machine for the first time, please read this instruction
manual carefully.
Pay special attention to safety at work to avoid injuring yourself or other
persons, or causing damage to objects.
Please follow the instructions in this guide to avoid damage to the tool.
The HotKnife 250 is a professional hot cutting tool for foamed plastics such as ETIC
blocks. The HotKnife 250 heats up the blade in just a few seconds and ensures opti-
mum temperature control via the temperature control device to ensure convenient and
efficient cutting.

Recommended applications

Suitable for cutting facade, roof and cellar insulation blocks made of Polystyrene (EPS),
Neopor, Peripor (Perimeter), Styrodur. Before use check the manufacturer's data sheet
for the material you intend to cut to avoid endangering your health.
Caution: When cutting material always ensure best possible ventilation.
Avoid vapours by using the correct cutting technique. Do not inhale vapours
when cutting.
35