Clarke BSW 28 Manuel D'utilisation page 4

EN
ENGLISH
WARNING! Do not leave the machine unattended if the main switch is not turned to "0" and without being
sure that it cannot move independently.
WARNING! Do not use the machine on slopes with a gradient exceeding the specifications.
WARNING! Do not wash the machine with direct or pressurized water jets, or with corrosive substances. Do
not use compressed air to clean this type of machine.
WARNING! While using this machine, take care not to cause damage to other people, and children especially.
WARNING! The machine storage temperature must be between +32°F and +104°F (0°C and +40°C).
WARNING! The machine operating temperature must be between +32°F and +104°F (0°C and +40°C).
WARNING! The humidity must be between 30% and 95%.
WARNING! Do not use the machine as a means of transport.
WARNING! Do not use the machine on slopes with a gradient exceeding the specifications (see Technical
Data paragraph).
WARNING! Do not allow the brooms to operate while the machine is stationary to avoid damaging the floor.
WARNING! In case of fire, use a powder fire extinguisher, not a water one.
WARNING! Do not bump into shelves or scaffoldings, especially where there is a risk of falling objects.
WARNING! Adjust the operation speed to suit the floor conditions.
WARNING! This machine cannot be used on roads or public streets.
WARNING! Do not remove or modify the plates affixed on the machine.
WARNING! Do not tamper with the machine safety guards and follow the ordinary maintenance instructions
scrupulously.
WARNING! If the machine is used according to the instructions, the vibrations are not dangerous. The
machine vibration level is less than 98.42 in/s
WARNING! Use only brooms supplied with the machine and those specified in the Operator's Manual. Using
other brooms could reduce safety.
WARNING! In case of machine malfunctions, ensure that these are not due to lack of maintenance. Otherwise,
request assistance from the authorized personnel or from an authorized Service Center.
WARNING! Carefully read all the instructions before performing any maintenance/repair procedure.
WARNING! To ensure machine proper and safe operation, the scheduled maintenance shown in the relevant
chapter of this Manual must be performed by the authorized personnel or by an authorized
Service Center.
4
2 2
(2.5 m/s ) (98/37/EEC - EN 1033/1995).
Operator's Manual - BSW 28