Product Description And Specifications - Bosch PCM 8 SD Notice Originale

26 | English
Do not use saw blades made from high speed steel
u
(HSS). Such saw blades can easily break.
Always use saw blades with correct size and shape
u
(diamond versus round) of arbour holes. Saw blades
that do not match the mounting hardware of the saw will
run off-centre, causing loss of control.
Do not replace the integrated laser with a laser of an-
u
other type. A laser that is not compatible with this power
tool could pose a risk to persons.
Never remove cuttings, wood chips, etc. from the cut-
u
ting area while the power tool is running. Always guide
the tool arm back to the neutral position first and then
switch the power tool off.
Do not touch the saw blade after working before it has
u
cooled. The saw blade becomes very hot while working.
The power tool is delivered with a warning sign
u
(marked in the illustration of the power tool on the
graphics page).
If the text on the warning label is not in your native
u
language, cover it with the label supplied, which is in
your language, before initial commissioning.
Never make warning signs on the machine unrecognis-
u
able.
Do not direct the laser beam at persons or
animals and do not look directly into the
laser beam or at its reflection. Doing so
could lead to blindless, or could cause acci-
dents or damage to the eyes.
If laser radiation hits your eye, you must close your
u
eyes and immediately turn your head away from the
beam.
Do not make any modifications to the laser equip-
u
ment.
Products sold in GB only:
Your product is fitted with an BS 1363/A approved electric
plug with internal fuse (ASTA approved to BS 1362).
If the plug is not suitable for your socket outlets, it should be
cut off and an appropriate plug fitted in its place by an au-
thorised customer service agent. The replacement plug
should have the same fuse rating as the original plug.
The severed plug must be disposed of to avoid a possible
shock hazard and should never be inserted into a mains
socket elsewhere.
Symbols
The following symbols may be important for the operation of
your power tool. Please take note of these symbols and their
meaning. Correctly interpreting the symbols will help you to
operate the power tool more effectively and safely.
Symbols and their meaning
Laser radiation
Do not stare into the beam
Laser class 2
1 609 92A 4M8 | (04.12.2018)
Symbols and their meaning
Keep hands away from the cutting area
while the power tool is running. Con-
tact with the saw blade can lead to injur-
ies.
Wear hearing protection. Exposure to
noise can cause hearing loss.
Wear safety goggles.
Wear a dust mask.
Danger zone. Keep hands, fingers and
arms away from this area.
To set mitre angles, the saw table has to
be turned with the lever pulled until the
angle indicator displays the required
mitre angle.
The adjustable fence must be pulled out-
wards when sawing bevel angles.
Take note of the dimensions of the saw
blade. The hole diameter must precisely
fit the tool spindle. If it is necessary to
use reducers, ensure that the dimensions
of the reducer are suitable for the base
blade thickness and the saw blade hole
diameter, as well as the tool spindle dia-
meter. Wherever possible, use the redu-
cers provided with the saw blade.
The saw blade diameter must match the
information specified on the symbol.
The cutting line can be indicated by the
laser beam on either the left or right of
the saw blade.
Product Description and
Specifications
Read all the safety and general instructions.
Failure to observe the safety and general in-
structions may result in electric shock, fire
and/or serious injury.
Bosch Power Tools