Kenwood CMOS-320 Mode D'emploi page 4

Installation
CAUTION
• T he adjustments during camera setting may be hindered
depending on the camera installation position. Do not
install the camera securely but attach it only temporarily
until the camera setting has completed.
Recommended Installation Position
Examples of correct camera installation on the
rear of the vehicle
Installation position
The CMOS-320 should be installed at a height of 50 cm (1.64
feet) or more.
Examples of correct camera installation on the
front of the vehicle (CMOS-320 only)
Installation position (standard)
Installation position (lower)
The CMOS-320 should be installed at a height of 30cm to 80cm
(0.98feet to 2.62feet).
4
|
CMOS-320/CMOS-220
Mount so that the "KENWOOD"
logo appears at the top.
Mount so that the "KENWOOD"
logo appears at the top.
Installing the Camera/Adjusting its
angle
1
Decide the camera installation position.
2
Clean the camera installation surface.
Using a commercially available cleaner, wipe dirt, moisture
and oil away from the surface on which the camera bracket
is to be attached.
3
Loosen the camera bracket retaining screws.
Perform steps 4 and 5 only when they are required.
4
If required, separate the camera bracket from
the camera and adjust the shape according to
the surface on which it will be attached.
Bend
Bend
Camera bracket
5
Mount the camera on the camera bracket.
Mount so that the "KENWOOD" logo appears at the top.
6
Fix the camera temporarily with tape, etc.
Using a piece of tape, etc., fix the camera temporarily.
12345
Install the camera at the center of the vehicle and not to
hide the number plate. And also install straight toward the
forward/reverse direction of the vehicle. Be careful not to
lean the camera toward other directions of the vehicle, etc.
7
Complete all of the required connections.
Using a commercially available
Phillips screwdriver, loosen the
two retaining screws.
Adjust the camera bracket
shape so that it fits the
camera installation
position.