Kenwood CMOS-320 Mode D'emploi page 11

• Select [ ] to invert the icon upside down.
3
After completing the adjustment, press the
view button.
Advances to "OVERHEAD VIEW IMAGE
ADJUSTMENT (Right-and-Left ANGLE)".
Overhead View Image Adjustment
(Right-and-Left Angle)
This item adjusts the horizontal angle (in the rotary
direction) of the camera installation position.
1
Select "OVERHEAD VIEW IMAGE ADJUSTMENT
(Right-and-Left ANGLE)".
2
Press the + or – button of the switch unit
so that the center of the parking space is
displayed vertically.
Adjustment is possible by one step to the left and right. If the
adjustment is not possible in the currently available range,
change the camera position before retrying.
3
After completing the adjustment, press the
view button.
Advances to "OVERHEAD VIEW IMAGE
ADJUSTMENT (Up-and-Down ANGLE)".
Overhead View Image Adjustment
(Up-and-Down Angle)
This item adjusts the vertical angle (inclination) of the
camera installation position.
1
Select "OVERHEAD VIEW IMAGE ADJUSTMENT
(Up-and-Down ANGLE)".
2
Press the + or – button of the switch unit so
that the lines indicating the vehicle width are
shown vertical.
Adjustment is possible by one step up and down. If the
adjustment is not possible in the currently available range,
change the camera position before retrying.
3
After completing the adjustment, press the
view button.
4
Select [Next].
Advances to "GUIDELINE ADJUSTMENT (Size)".
11
|
CMOS-320/CMOS-220