Kenwood CMOS-320 Mode D'emploi page 14

Display View Switching (CMOS-320 only)
Display View Switching
The CMOS-320 camera system can display 4 kinds of camera
images.
1
With an image displayed on the monitor, press
the view button of the switch unit.
Each press switches the image display mode in the following
order.
Ultra Wide View
Wide-angle image covering a horizontal angle of about 195°.
Wide View
Camera image covering a horizontal angle of about 135°.
Overhead View
Image seen from the viewpoint straight up above the vehicle.
Depending on the camera installation position, the Overhead
View image may not be displayed correctly.
• Overhead View may appear twice, depending on the
connected navigation system.
14
|
CMOS-320/CMOS-220
Corner View
The views seen from the two corners of vehicle are displayed
on the left and right halves of the screen.
When connecting the camera to a Kenwood navigation
system etc, (Control unit) equipped with the camera control
function, use the provided control unit connection cord. This
allows the control unit to switch the display view as well on
touch the control unit screen (page 8).