Kenwood CMOS-320 Mode D'emploi page 13

Wide View Guideline Adjustment
(Red Line Position Setting)
This item adjusts the position of the red line displayed in
the wide view. The red line can be used independently to
set the reference line for the vehicle parking position.
1
Select "GUIDELINE ADJUSTMENT (Red Line
Position Setting)".
2
Press the + or – button of the switch unit to
adjust the position of the red line.
Move the red line until the edge of your vehicle's bumper.
If the edge of your vehicle's bumper cannot be seen in the
monitor, move the red line around the edge of your vehicle.
3
After completing the adjustment, press the
view button.
4
Select [Next].
Advances to "SETTING COMPLETE".
Finishing the Camera Setting
1
Press the + or – button of the switch unit to
select [Finish] and press the view button.
Camera ID Setting
When connecting a CMOS-320 as a front camera to a
Kenwood navigation system equipped with the camera
control function, it is required to assign the ID to [Front
Camera].
1
Install the switch unit.
Refer to "Basic Connections" (page 7) for the connection.
2
Display the image of the front camera on the
monitor of the Kenwood navigation system.
For displaying the image, refer to the instruction manual of it.
3
Press and hold the + button of the switch unit
for more than 2 seconds, and then press and
hold the – button for more than 2 seconds.
4
Press the + or – button of the switch unit
to select the camera ID, and press the view
button.
5
After setting, press the + or – button of the
switch unit to select [Finish] and press the view
button.
6
Turn off the ACC.
7
Disconnect the switch unit.
8
Connect CAM+/CAM– to the Kenwood car
navigation system.
9
Turn on the ACC.
13
|
CMOS-320/CMOS-220