Fcc Compliance Statement - DSC PK55 Serie Instructions D'installation

Limited Warranty
Digital Security Controls warrants that for a
period of 12 months from the date of purchase,
the product shall be free of defects in materials
and workmanship under normal use and that in
fulfilment of any breach of such warranty, Digital
Security Controls shall, at its option, repair or
replace the defective equipment upon return of
the equipment to its repair depot. This warranty
applies only to defects in parts and workmanship
and not to damage incurred in shipping or han-
dling, or damage due to causes beyond the con-
trol of Digital Security Controls such as lightning,
excessive voltage, mechanical shock, water
damage, or damage arising out of abuse, alter-
ation or improper application of the equipment.
The foregoing warranty shall apply only to the
original buyer, and is and shall be in lieu of any
and all other warranties, whether expressed or
implied and of all other obligations or liabilities on
the part of Digital Security Controls. Digital Secu-
rity Controls neither assumes responsibility for,
nor authorizes any other person purporting to act
on its behalf to modify or to change this warranty,
nor to assume for it any other warranty or liability
concerning this product.
In no event shall Digital Security Controls be lia-
ble for any direct, indirect or consequential dam-
ages, loss of anticipated profits, loss of time or
any other losses incurred by the buyer in connec-
tion with the purchase, installation or operation or
failure of this product.
Warning: Digital Security Controls recommends
that the entire system be completely tested on a
regular basis. However, despite frequent testing,
and due to, but not limited to, criminal tampering or
electrical disruption, it is possible for this product to
fail to perform as expected.
Important Information:Changes or modifications
not expressly approved by Digital Security Controls
could void the user's authority to operate this equip-
ment.
©2006 Digital Security Controls, Toronto, Canada • www.dsc.com
Tech. Support, Centre d'aide: 1-800-387-3630 (Canada, US), 905-760-3036

FCC Compliance Statement

Caution: Changes or modifications not expressly
approved by Digital Security Controls could void
your authority to use this equipment.
This equipment generates and uses radio fre-
quency energy and if not installed and used prop-
erly, in strict accordance with the manufacturer's
instructions, may cause interference to radio and
television reception. It has been type tested and
found to comply with the limits for Class B device
in accordance with the specifications in Subpart
"B" of Part 15 of FCC Rules, which are designed to
provide reasonable protection against such inter-
ference in any residential installation. However,
there is no guarantee that interference will not
occur in a particular installation. If this equipment
does cause interference to television or radio
reception, which can be determined by turning the
equipment off and on, the user is encouraged to
try to correct the interference by one or more of the
following measures:
• Re-orient the receiving antenna
• Relocate the alarm control with respect to the
receiver
• Move the alarm control away from the receiver
• Connect the alarm control into a different outlet
so that alarm control and receiver are on different
circuits.
If necessary, the user should consult the dealer or
an experienced radio/television technician for
additional suggestions. The user may find the fol-
lowing booklet prepared by the FCC helpful: "How
to Identify and Resolve Radio/Television Interfer-
ence Problems". This booklet is available from the
U.S. Government Printing Office, Washington,
D.C. 20402, Stock # 004-000-00345-4.
This Class B digital apparatus complies with
Canadian ICES-003.
Cet appareil numérique de la classe B est con-
forme à la norme NMB-003 du Canada.
IC:160A-RFK55XX4
The term IC before the radio certification number
signifies that the Industry Canada technical speci-
fications were met.
EN5131-1 Grade2/Class II
Operating Instructions shall be made available to
the user.