SOLIS BARISTA PERFECT 118 Mode D'emploi page 45

RUN N I NG T H E CL EA N IN G CYC LE
■
Through regular use, residues of coffee powder and coffee oil form in the appliance,
impairing the brewing process. Therefore, you should perform a cleaning cycle once
every 2 to 3 months.
➊ ➋ ➌
Please proceed as follows:
– Empty the drip tray and fill the water tank.
1. Place the rubber disk in the filter insert (for one or two cups) and the filter insert
in the portafilter.
2. Place a SOLITABS cleaning tablet (without sponge) in the filter insert, on the
rubber disk.
3. Twist and install the portafilter in the brewing head.
4. Switch the machine on by pressing the POWER button. Wait for the control light
in the button surround lights up constantly.
5. Turn the selection knob to the „Espresso" position
the selection knob to the standby position in the center. Repeat both steps until
the cleaning tablet has completely dissolved.
6. Switch the appliance off with the POWER button, remove the portafilter and
check if the SOLITABS tablet has completely dissolved. Should this not be the
case, repeat steps 3 to 5 until the tablet has completely dissolved. Should the
SOLITABS tablet have dissolved, rinse the portafilter and the filter basket with
warm water.
– Should you encounter problems when making espresso the next time, please refer
to the section „Troubleshooting" for ideas on how to solve the problem.
– The Troubleshooting section can be found on page 93–95.
– SOLITABS cleaning tablets are available from good specialist retailers or from
Solis of Switzerland Ltd.
Telephone: 0848 804 884, Telefax: 0848 804 890
email: info.ch@solis.com or www.solis.ch
(Shipping only within Switzerland)
88
20 SECONDS
➍ ➎ ➏
for 20 seconds. Return
CL E ANI NG THE ST EAM W AND
■
from wand after texturing each use
➊ ➋
The steam wand must always be cleaned each time after texturing milk.
Proceed as follows:
1. Point the steam wand towards the drip tray and turn the selection knob to the
„Steam" position . By doing this, you remove potential milk residue in the
steam wand by letting some steam run through.
Return the selection knob to the center, to the standby position. Switch the
machine off with the POWER button and let the appliance cool down.
2. Wipe the outside of the steam wand with a damp cloth.
3. If the steam wand remains blocked, use the pin on the cleaning tool to clear
the opening.
4. If the steam wand remains blocked at all, the tip of the steam wand can be re-
moved by using the spanner in the centre of the cleaning tool. Unscrew the tip.
5. Soak the tip in hot water before using the pin on the cleaning tool to unblock.
Replace the tip back onto the steam wand and secure with the spanner in the
cleaning tool.
➌ ➍ ➎
89