MCS Master DH 751 Manuel D'utilisation Et De Maintenance page 39

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 33
Do not use the unit near water. The unit might
BG
be damaged when soaked in water, so as to re-
sult in fire or electric shock.
CZ
DE
► FIG. 15
Use
the
standard
DK
220-240V/~50Hz. Otherwise it might result in
fire or electric shock.
EE
► FIG. 16
ES
Do not damage the wire. Do not put anything
heavy on the wire or heat or pull the wire. Other-
FI
wise it might result in fire of an electric shock.
FR
► FIG. 17
Clean the dirt on the plug and fix it tightly. If the
GB
plug is not fixed tightly, it might cause an electric
shock.
HR
► FIG. 18
HU
Do not regard the plug as a switch. Otherwise it
might result in fire or an electric shock.
IT
LT
►►
5.
NOTICES ABOUT UNIT OPERA-
TION
LV
► When moving the unit, do not tilt over 45°to
NL
avoid any damaging of the compressor.
► The unit should be operated between 5°~32°.
NO
► When dehumidifying, because of the heat re-
sulted from the running compressor, the indoor
PL
temperature will rise by 1°~3°. Such a reaction
should be considered as normal.
RO
► When indoor temperature is below 10°, and
the ambient absolute humidity is quite low, it is
RU
unnecessary to use the machine.
► Air inlet and air outlet should be at least 10cm
SE
away from the wall.
► Try to keep the room closed to enhance the
SI
dehumidification effect.
► Too much dirt on the filter affects dehumidi-
SK
fication, may even result in malfunctioning of it,
UA
thus it should be cleaned at least once a month.
If there is a great amount of powder in the air,
SE
the filter must be cleaned once a week, or even
every day. Pull the front panel out and clean the
SI
filter. If necessary, you may slightly knock all
over the filter, use a vacuum cleaner to remove
SK
bigger pieces of dirt or even wash the filter in
warm clean water (≤40% with some neutral de-
tergents) and then dry it.
►►
6. TROUbLE-SHOOTING
electric
source
of
UNIT DOES NOT wORK
► analysis
1.Power cut
2.Switch off
3.Unplugged
4.Fuse melted
5.Tank full
► Solution
1.Power on
2.Switch on
3.Plug on
4.Exchange fuse
5.Empty the tank and replace it
DEHUMIDIFIES IN INADEQUATELY
► analysis
1.Filter choked by dirt
2.Some barrier
in air inlet or outlet
3.Door or windows open
4.Refrigerant leakage
► Solution
1.Clean the filter
2.Remove the barrier
3.Close the door and windows and
seclude from the sunshine
4.Contact the manufacturer or seller
wATER LEAKAGE
► analysis
1.The unit is inclined
2.Drainer choked
► Solution
1.Adjust the unit to be stable
2.Pull out the panel and remove the barrier
STRANGE NOISE
► analysis
1. Until instable
2. Filter choked
► Solution
1.Place the unit stably
2.Clean the filter
► When above malfunctions occur and they
could not be removed, please contact the supp-
lier or seller, do not disassemble the machine
yourself.
► When the unit starts or stops running, it ma-

Publicité

Table des Matières
loading

Table des Matières