Putting Into Operation - Waldmann OT 209 Mode D'emploi

GB Instructions for use Office Task Light OT/OTE 209 „DELIGHT"
Mounting
The light must be positioned stably
on the mounting surface by means
of a desk clamp, desk stand or a
wall holder.
When using mounting elements
which have not been proposed by
the manufacturer, the user has to
verify their reliability.

Putting into operation

The device can be connected to
any earthed socket. Before putting
the light into operation, however,
the user has to check whether the
mains voltage is identical to the
rated voltage and the frequency
specified on the rating plate.
Positioning
Instructions for the correct installation
and setting of the light please see
figures 2.1 through 2.4 on page 3.
Adjusting the articulation
joints
The joints are adjustable. Each
joint must be adjusted so that the
lamp is - on the one hand - easily
movable and - on the other hand
- remains in the position wished
by the user.
The friction of the reflector joints
can be adjusted at the screws [3.1]
(see fig. 3 on page 3).
Operation
Switch-on and switch-off
The light can be switched on/
off with the switch on the lamp
head.
Fig. 5
9