Pontec PondoRell 3000 Notice D'emploi page 13

Information about these operating instructions
You made a good choice with the purchase of this product PondoRell 3000.
Prior to commissioning the unit, please read the instructions of use carefully and fully familiarise yourself with the unit.
Ensure that all work on and with this unit is only carried out in accordance with these instructions.
Adhere to the safety information for the correct and safe use of the unit.
Keep these instructions in a safe place! Please also hand over the instructions when passing the unit on to a new
owner.
Symbols used in these instructions
Warnings
The warning information is categorised by signal words, which indicate the extent of the hazard.
W A R N I N G
• Indicates a possibly hazardous situation.
• Non-observance may lead to death or serious injuries.
C A U T I O N
• Indicates a possibly hazardous situation.
• Non-observance may lead to slight or minor injuries.
N O T E
Information for the purpose of clarification or for preventing possible damage to assets or to the environment.
Additional information
 A Reference to a figure, e.g. Fig. A.
→ Reference to another section.
Intended use
PondoRell 3000, referred to as "unit", may only be used as specified in the following:
• For cleaning garden ponds.
• For operation with clean water.
• Operate in accordance with instructions.
The UVC lamp installed in the unit is intended to kill algae and bacteria in the pond water. Even in small doses, its radi-
ation is harmful for eyes and skin. Never use the UVC lamp in a defective housing or outside the housing, or any other
purpose other than that intended.
The following restrictions apply to the unit:
• Do not use in swimming ponds.
• Never use the unit to convey fluids other than water.
• Never run the unit without water.
• Do not use for commercial or industrial purposes.
• Do not use in conjunction with chemicals, foodstuff, easily flammable or explosive substances.
Installation
 A
Screw either the nozzle tube (11) or the stepped hose adapter with O ring 12x4 (12) onto the connection thread. If you
use the nozzle tube, connect the desired fountain nozzle (13) to the connection socket (14). Place the unit in the pond
as horizontal as possible on firm, sludge-free ground and ensure that it is completely covered with water at a maximum
of 2 meters below the surface of the water.
- EN -
13