Intended Use; Scope Of Supply; Product Overview; Before You Begin - Chamberlain ML800EV Notice De Montage

2

Intended use

The device is intended for the opening and closing of garage doors
(please refer to section 6 "Door Types").
The device is not meant for commercial use but solely for the use in
private garage doors that are appropriate for a single household.
Any improper use of the drive could increase the risk of accidents.
The manufacturer assumes no liability for such usage.
3

Scope of supply

Please check the supplied parts for completeness before starting the instal-
lation. Note: The numbering only applies to the corresponding section.
Parts overview (Drivehead):
1. Drive head
2. Remote control
ML800EV, ML1000EV-S
ML1000EV-F
3. Support bracket
4. Hardwarebag
5. Emergency release
6. Wireless wall control
ML1000EV-F
Hardwarebag:
1. Truss head screw
6 x 80 mm
2. Lock nut M6
3. Hexagonal head screw
4. Nut M6
5. Bolt
4

Product overview

This figure always offers you a complete overview of the ready-
assembled system during the step by step installation of the system.
1. Header bracket
2. Belt
3. Rail
4. Carriage
5. Connecting piece
6. Mounting bracket
7. Support bracket
Parts overview (Rail):
1x
7. Header bracket
2x
8. Door bracket
9. Adapter for gear wheel
3x
10. Curved door arm
1x
11. Support bracket
1x
12. Hanging bracket
1x
13. Rail
1x
6. Safety cotter pin
7. Screw ST6 x 50 mm
1x
8. Screw ST6,3 x 18 mm 2x (4x)
1x
9. Plug
4x
4x
1x
8. Power cable
9. Drive head
10. Release
11. Straight door arm
12. Curved door arm
13. Door bracket
5

Before you begin

IMPORTANT NOTE
If your garage does not have a side entrance, an external emergency
release should be installed. This allows for manual operation of the garage
door from the outside during power failure.
6

Door Types

A. One-Piece Door with Horizontal Track Only.
B. One-Piece Door with Horizontal and Vertical Track – Special door arm
(E, The Chamberlain Arm™) and the Protector System™
required. See your dealer.
C. Sectional Door with Curved Track – See 20B – connect door arm.
D. Canopy door – Special door arm (E, The Chamberlain Arm™) and the
1x
Protector System™ required. See your dealer.
E. The Chamberlain Arm™ for use on door types B and D.
1x
1x
6.1

Preparation

1x
First, check whether your door is balanced and in equilibrium.
2x
Open your door about halfway and let it go.
2x
The door can now hardly change its position independently,
but must remain in this position held by the spring force alone.
1x
1. The rail of the garage door MUST be connected securely and firmly to
the supporting wall or ceiling above the garage door.
1x
2. Additional brackets and mounting rails (not included in the supply) might
be required, if the your garage ceiling has a cladding, boards or similar.
4x
3. If your garage does not have a separate side entrance, an external
emergency release (refer to section 34 "Optional Accessories") must be
4x
installed.
7

Tools required

Tool list:
Ladder
Marking pen
Pliers
Drilling machine
Hammer
Ratchet (10, 13 mm)
Hacksaw
Different drill bits for concrete
and(or wood (8, 6, 5, 4.5 mm)
Box wrench
Water level
Screwdriver
Measuring tape
en 02/13