Quinny XL Fashion 3 Mode D'emploi & Garantie page 21

GB
- Check to make sure the carrycot is fastened securely.
Removing the Dreami carrycot
- Place your thumbs on the control buttons on both sides of the carrycot (18/1).
- Push in the buttons while lifting the carry cot from the Fashion 3 XL (18/2).
Fitting the Maxi-Cosi car seat
- Unfold the pushchair and place the car safety seat onto the adapters with the foot end between the sides of
the handle (19).
- Check to make sure the car seat is fastened securely.
Removing the Maxi-Cosi car seat
- Place your thumbs on the control buttons on both sides of the car seat (20.1).
- Push in the buttons while lifting the car seat from the Fashion 3 XL (20.2).
Removing adapters
- Remove the adapters by moving the red button under the adapters outward (21.1) while sliding the adapters
upwards (21.2).
- Place both guards back in the adapter connections.
When used as a pushchair (see illustrations 22 - 35)
Placing the pushchair seat
- The pushchair seat can be attached in a forward-facing (22) or a backward-facing (26) position.
- Slide the hooks on the pushchair seat (22) onto the front or back projections (depending on the direction
desired) on the frame (23).
- Now push the pushchair seat downwards onto the rod in the middle of the frame (24).
- You should hear a clearly audible "click".
- Check to make sure the pushchair seat is secure by pulling on it.
- Remove the pushchair seat by pressing both red buttons (behind the seat bottom) and pulling the seat
upward (25).
Footrest
- The footrest can be adjusted into 3 positions.
- Press both buttons on the sides of the footrest at the same time and move the footrest to the desired position (27).
- IMPORTANT: Never let your child sit or stand on the footrest!
Adjusting the back
- The back of the pushchair seat has multi-positional adjustment.
- To lower the back: Pull up the handle on the back of the seat back and push the back downward (28).
- To raise the back: Simply pull the back upward.
Attaching/removing sun canopy
- Push both ends of the sun canopy into the plastic holders on the handlebar (29).
- Check to make sure the sun canopy is fastened securely.
- To remove the sun canopy, push in the spring catches on both ends (30.1) and pull the sun canopy out
of the holders (30.2).
Safety harness
- Apply the brakes on the Fashion 3 XL.
- Make sure the safety harness is loosened before placing your child (carefully!) into the seat.
- Fasten the lap and shoulder belts to the crotch strap (32).
- Adjust the belts to the size of your child by lengthening or shortening the belts using the clasps (33).
- Push the buttons to open the fastener (31).
- There are D rings for securing an additional safety harness. Make sure any safety harness you use meets the
20
following standard: BS 6684.