How Does Marmitek X-10 Work - Marmitek UM7206 Guide Utilisateur

UM7206™
UNIVERSAL RECEIVER
SAFETY WARNINGS
• To prevent short circuits, this product should only be used inside and only in dry spaces. Do
not expose the components to rain or moisture. Do not use the product close to a bath,
swimming pool etc.
• Do not expose the components of your systems to extremely high temperatures or bright
light sources.
• Do not open the product: the device may contain live parts. The product should only be
repaired or serviced by a qualified repairman.
• In case of improper usage or if you have opened, altered and repaired the product yourself,
all guarantees expire. Marmitek does not accept responsibility in the case of improper
usage of the product or when the product is used for purposes other than specified.
Marmitek does not accept responsibility for additional damage other than covered by the
legal product responsibility.
• This product is not a toy. Keep out of reach of children.
• Only connect the adapter to the mains after checking whether the mains voltage is the
same as the values on the identification tags. Never connect an adapter or power cord
when it is damaged. In that case, contact your supplier.
• Automatic switching devices provide comfort, but can also be dangerous. They can surprise
people or can ignite clothing hanging over an electric heat source. Please be careful and
take appropriate measures to avoid accidents.

HOW DOES MARMITEK X-10 WORK?

Marmitek X-10 components use the existing mains wiring to communicate (using Marmitek
X-10 signals). You can build a complete system using the three different kind of components
of the Marmitek X-10 System:
1. Modules: These components will receive Marmitek X-10 signals and will switch or dim the
attached lamp or appliance.
2. Controllers: These components will transmit Marmitek X-10 signals and thus will control
the Modules.
3. Transmitters: Wireless components like remotes. The signals of these components will
be received by a controller with transceiver functionality (IRRF 7243, TM13 or console of
a Marmitek Security System). The Transceiver will translate the signals into Marmitek X-10
signals on the power line.
ADRESSES
Up to a maximum of 256 different addresses can be preset. These are subdivided into a so-
called HouseCode (A to P incl.) and a UnitCode (1 to 16 incl.). The HouseCode can also be set
on the controllers, so that the controllers and modules become part of the same system. The
address can be set either using code dials or by pressing buttons, depending on the type of
module.
UM7206™ 3