Overlay Series Custom Panels - KitchenAid KBBL206ESS Guide D'installation

36" (91.4 cm) French Door Models
90˚
110˚
Custom overlay panels allow you to blend the exterior of your
refrigerator into the overall kitchen decor and to use custom
handles for additional design flexibility.
The custom panels must have backer panels attached in order to
mount them to the refrigerator. It is most common to work with
three panels, as shown in the following graphic: a decorative
overlay panel, a 1/8" (3.18 mm) spacer panel or spacer strips and
a 1/4" (6.35 mm) backer panel.
Overlay Panel
Spacer Panel
Backer
Panel
5/8" to 3/4"
1/4"
(15.88 to
1/8"
(6.35 mm)
19.05 mm)
(3.18 mm)
10
39 3 / "
4
(101 cm)
41"
(104 cm)
90˚
110˚

Overlay Series Custom Panels

Spacer Panel
1/8"
(3.18 mm)
Overlay Panel
Backer Panel
1" minimum
(2.54 cm)
Door/Grille Trim
Offset Dimension
42" (106.7 cm) French Door Models
90˚
110˚
In some cases, your cabinet manufacturer may choose to work
with one panel routed for the different dimensions. Follow these
panel dimension and placement instructions to be sure that the
custom overlay panels will fit properly.
IMPORTANT:
For 36" (91.4 cm) single-door models, the refrigerator door
■
overlay panel cannot exceed 50 lbs (23 kg) and the freezer
drawer overlay panel cannot exceed 20 lbs (9.1 kg).
For 36" (91.4 cm) and 42" (106.7 cm) French-door models, the
■
refrigerator door overlay panel cannot exceed 30 lbs (13.5 kg)
and the freezer drawer overlay panel cannot exceed 25 lbs
(11.4 kg).
The weight of the top grille overlay panel cannot exceed
■
10 lbs (4.5 kg) for both models.
To minimize panel weight, you may use 2" (5.08 cm) spacer strips
around the perimeter in place of full-sheet solid spacer panels.
The spacer strips must be set in at least 1" (2.54 cm) from the
top, bottom and side edges of the backer panel. If you use spacer
strips, it is also recommended that you use two 2" (5.08 cm)
strips horizontally centered for added support.
42 / "
3
4
(108.6 cm)
44 / "
1
4
(112.3 cm)
90˚
110˚