Installation Requirements; Tools And Parts - KitchenAid KBBL206ESS Guide D'installation

Stainless Steel Series (42" [106.7 cm] Models)
Features wraparound styling that complements the contoured
door handles. This series provides a warm commercial-looking
built-in refrigerator.
KBFN402ESS, KBFN502ESS
Black Stainless Steel Series (42" [106.7 cm] Models)
KBFN502EBS
IMPORTANT:
Installer: Leave Installation Instructions with the homeowner.
■
Homeowner: Keep Installation Instructions for future
■
reference. Save these Installation Instructions for the local
electrical inspector's use.
Tools Needed
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Cordless drill
■
Drill bits
■
Adjustable wrenches (2)
■
Phillips screwdriver
■
Small level
■
Appliance dolly
■
TORX is a trademark of Acument Intellectual Properties, LLC.
†

INSTALLATION REQUIREMENTS

Tools and Parts

Torx T15 and T27
†
■
screwdrivers
11/32" nut driver
■
3/8", 1/4", and 1/2"
■
open-end wrenches
5/32" hex key
■
1/4" and 5/16" socket
■
drivers
Tape measure
■
Utility knife
■
Overlay Series (42" [106.7 cm] Models)
Features factory-installed, overlay style trim, to provide a
"frameless" look. This series requires the installation of custom
panels, handles, and standoffs.
KBFN402EPA, KBFN502EPA
Parts Needed
#8 x 3" (7.6 cm) wood screws
■
(longer screws may be needed) (6)
2" x 4" x 32" (5 cm x 10 cm x 81 cm) wood board(s) (1 or 2)
■
Make custom panels or consult a qualified cabinetmaker or
■
carpenter to make the panels.
Overlay Series: Make custom panels, or consult a qualified
cabinetmaker or carpenter to make the panels. See
"Installation Requirements" for more information.
Stainless Series and Black Stainless Series are shipped
complete.
If you are connecting the water line directly to copper tubing
■
and not to a shutoff valve, you need a ferrule, a union, and a
1/4" compression fitting.
5