Philips LED4 Mode D'emploi page 6

• Place the control box in an appropriate position according to the
surroundings as shown in Figure 7. Do not install the control box in
a high-temperature area, an area with moving parts, or an area that
may interfere with other moving parts.
• Connect the 3- pins connector of the burner to the control box
as shown in Figure 8. Ensure that the plastic cover is attached tightly.
• Connect the power connector as shown in Figure 9.
• Check that the high and low beams of the LED4 headlight bulb both function correctly.
• If the beams are positioned too high or too low, adjust the light axis to an appropriate position
as needed.
• Store the original H4 bulb and the LED4 headlight instruction manual in a safe place.
Troubleshooting
4
If the LED4 headlight fails to operate, please perform the following actions:
1. Check that the power connectors are well connected.
2. Ensure that the vehicle headlight switch is in the "ON" position.
3. Ensure that the vehicle battery has enough power to power the LED4 headlight.
Recycling
5
Your product is designed and manufactured with high quality material and
components that can be recycled and reused. The following symbol attached
to the product signifies that the product is covered by the European Directive
2002/96/EC.
Never dispose of the product with other waste. Please inquire about the local
regulations about the separated collection of electrical and electronic products.
The correct disposal of used old products helps prevents potentially negative
consequences on the environment and human health.
6
Figure -7
Figure -8
Figure -9