Philips Lightolier LyteProfile LED Gen 3 Installation

Downlighting
LyteProfile LED Gen 3
& EasyLyte
Light Engine Trims
This luminaire is intended for installation in accordance with the National Electrical Code and local regulations. To
assure full compliance with local codes and regulations, check with your local electrical inspector before installation.
To prevent electrical shock, turn off electricity at fuse box before proceeding. Allow fixture to cool before handling.
Retain these instructions for maintenance reference
Installation for LyteProfile & EasyLyte
Light Engine Trims:
• P4SDL_ series
• P4RDL_ series
• P6SDL_ series
• P6RDL_ series
• P4SLW_ series
• P4RLW_ series
• P6SLW_ series
• P6RLW_ series
• P4RSL_ series • Z4RDL_ series
• P6RSL_ series • Z6RDL_ series
Instructions for all applications
Fig.A
Adjustment
Ladder
Step 1
Trim Spring
Set Trim Springs to the correct position for the ceiling
thickness. Adjustment Ladders can be positioned every
¼" to fit various ceiling heights. To adjust, gently
disengage shim on trim spring, slide spring to appropriate
ladder setting, and allow to click into place. See Fig. A
Note: Trim can be removed by grasping reflector flange and pulling straight down.
© 2018 Philips Lighting Holding B.V. All rights reserved. Philips reserves the right to make changes in specifications and/or to discontinue any product
at any time without notice or obligation and will not be liable for any consequences resulting from the use of this publication. Philips.com/luminaires
12/5/2018 page 1 of 1 Philips.com/luminaires
Read and understand these instructions
Before installing luminaire (fixture).
Light Engine
Trim Reflector
Fig.B1
Step 2
Feed Driver from Light Engine through the aperature
hole in the ceiling and snap into J-Box. Squeeze the two
Trim Springs upward while pushing the Trim Reflector up
into the ceiling cutout. See Figs.B1 & B2..
IS-P_R_U
Caution (RISK OF FIRE)
Use only with LED light engines and reflector
Trims provided by Philips Lightolier. Use of other manufacturers
trims may void the Underwriters Laboratories listening and could
.
constitute a fire hazard
Driver
Fig.B2
J-Box
442100167590