Publicité
Les langues disponibles
Les langues disponibles
Liens rapides
INSTALLATION
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS
FOR FUTURE REFERENCE.
Fixtures must be wired in accordance with the National Electrical Code and all
applicable local codes. Proper grounding is required for safety. This product must be
installed in accordance with the applicable installation code by a person familiar with the
construction and operation of the product and the hazards involved.
WARNING: Make certain power is OFF before installing or maintaining fixture.
INSTALLATION
1. Remove (6) #8-32 set screws.
2. Wire Guard mounts with six #8-32 stainless steel screws to door as shown.
Hardware is provided with guard.
CLEANING
Clean glass lens with nonabrasive glass cleaning solution.
CAUTION: Be sure fixture temperature is cool enough to touch. Do not clean or
maintain while fixture is energized.
© 2016 Philips Lighting Holding B.V. All rights reserved.
www.philips.com/luminaires
Part Number 443561205910 Rev. D
Page 1 of 2
LPF4 WIRE GUARD
(6) #8-32 Set Screws
Publicité
Manuels Connexes pour Philips LPF4 WIRE GUARD
Sommaire des Matières pour Philips LPF4 WIRE GUARD
- Page 1 Clean glass lens with nonabrasive glass cleaning solution. CAUTION: Be sure fixture temperature is cool enough to touch. Do not clean or maintain while fixture is energized. © 2016 Philips Lighting Holding B.V. All rights reserved. www.philips.com/luminaires Part Number 443561205910 Rev. D...
- Page 2 Nettoyer la vitre avec une solution non abrasive pour le verre. ATTENTION Assurez-vous que l’appareil est froid au toucher. Ne pas nettoyer ou entretenir lorsque l’appareil est en fonction. © 2016 Philips Lighting Holding B.V. All rights reserved. Philips Lighting North America Philips Lighting Canada Ltd. www.philips.com/luminaires...