Philips LPF2 STONE GUARD Installation

INSTALLATION
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS
FOR FUTURE REFERENCE.
Fixtures must be wired in accordance with the National Electrical Code and all applicable local codes.
Proper grounding is required for safety. This product must be installed in accordance with the
applicable installation code by a person familiar with the construction and operation of the product
and the hazards involved.
WARNING: Make certain power is OFF before installing or maintaining fixture.
INSTALLATION
1.
Remove (4) #8-32 set screws.
2. Stone Guard mounts with (8) #8-32 stainless steel screws and washers to door as shown.
CLEANING
Clean lens with nonabrasive glass cleaning solution.
CAUTION: Be sure fixture temperature is cool enough to touch.
Do not clean or maintain while fixture is energized.
© 2016 Philips Lighting Holding B.V. All rights reserved.
www.philips.com/luminaires
Part Number 443561205840 Rev. D
Page 1 of 2
LPF2 STONE GUARD
(4) #8-32 Set Screws