Philips LED4 Mode D'emploi page 5

How to install the LED4 headlight onto your vehicle
3
• Take the original bulb and gasket out of the light fixture.
• Unscrew the heat sink from the LED4 headlight as shown in Figure 3.
• Attach the LED4 burner into the bayonet of the light fixture as shown in Figure 4.
• Attach the metal spring.
• Assemble the gasket on the LED4 burner and ensure it is in the correct position as shown in Figure 5.
• Adjust the heat sink into the correct position until it cannot rotate further as shown in Figure 6.
Ensure that the air inlet channel for the heat sink is not blocked.
Figure -3
Figure -4
Figure -5
Figure -6
5