Publicité
Les langues disponibles
Les langues disponibles
Liens rapides
INSTALLATION
LPF1 WIRE GUARD
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS
FOR FUTURE REFERENCE.
Fixtures must be wired in accordance with the National Electrical Code and all applicable local codes.
Proper grounding is required for safety. This product must be installed in accordance with the
applicable installation code by a person familiar with the construction and operation of the product
and the hazards involved.
WARNING: Make certain power is OFF before installing or maintaining fixture.
(4) #8-32 Set Screws
INSTALLATION
1. Remove (4) #8-32 set screws.
2. Wire Guard mounts with four #8-32 stainless steel screws to door as shown.
Hardware is provided with guard.
CLEANING
Clean glass lens with nonabrasive glass cleaning solution.
CAUTION: Be sure fixture temperature is cool enough to touch. Do not clean or maintain while
fixture is energized.
© 2016 Philips Lighting Holding B.V. All rights reserved.
www.philips.com/luminaires
Part Number 443561205820 Rev. D
Page 1 of 2
Publicité
Manuels Connexes pour Philips LPF1
Sommaire des Matières pour Philips LPF1
- Page 1 Clean glass lens with nonabrasive glass cleaning solution. CAUTION: Be sure fixture temperature is cool enough to touch. Do not clean or maintain while fixture is energized. © 2016 Philips Lighting Holding B.V. All rights reserved. www.philips.com/luminaires Part Number 443561205820 Rev. D...
- Page 2 Nettoyer la vitre avec une solution non abrasive pour le verre. ATTENTION Assurez-vous que l’appareil est froid au toucher. Ne pas nettoyer ou entretenir lorsque l’appareil est en fonction. © 2016 Philips Lighting Holding B.V. All rights reserved. Philips Lighting North America Philips Lighting Canada Ltd. www.philips.com/luminaires...