Dometic Waeco PerfectView CAM44 Instructions De Montage Et De Service page 40

Fitting the camera
Attaching the camera and camera guard
A
NOTICE!
Never mount the camera without the additional camera guard.
To mount the camera guard, only use the M3 x 6 mm screws
provided. Longer screws will damage the camera.
➤ Push the camera guard (fig. 8 3, page 5) over the camera in such a way
that:
– The fixing hole of the camera guard (fig. i, page 8) is over the 3 mm
thread of the camera.
– The two other fixing holes (fig. j, page 8) are over the 4 mm threads
of the camera.
➤ Secure the camera guard with the two M3 x 6 mm screws in the hole
(fig. i, page 8).
➤ Push the camera into the bracket (fig. j, page 8).
A
NOTICE!
Only use the screws supplied to mount the camera in the camera
holder. Longer screws will damage the camera.
➤ Secure the camera loosely with the four M3 x 8 mm screws in the two
other fixing holes (fig. j, page 8).
The camera is now centred.
➤ Align the camera so that the lens is at an angle of approx. 20° to the ver-
tical axis of the vehicle (fig. k, page 8).
I
NOTE
Do not tighten the four M3 x 8 mm screws until you have aligned
the camera (see chapter "Checking the function and setting the
camera" on page 42).
To do this you must first install and connect a monitor.
40
PerfectView CAM44
EN