Dometic Waeco PerfectView CAM44 Instructions De Montage Et De Service page 38

Masquer les pouces Voir aussi pour Waeco PerfectView CAM44:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 45
Fitting the camera
 If you are not sure about the location you have chosen, ask your vehicle
manufacturer or dealer.
I
NOTE
We recommend greasing the threads of the screws to prevent
corrosion.
To perform the installation, proceed as follows:
➤ Hold the camera holder at the chosen location and mark at least two dif-
ferent points for the drill holes (fig. e, page 7).
➤ Using a hammer and centre punch, gently pre-punch the previously
marked points to prevent the drill head from slipping off.
If you want to screw on the camera with self-tapping screws (fig. f,
page 7)
A
NOTICE!
Self-tapping screws may only be fastened to steel metal with a
minimum thickness of 1.5 mm.
➤ Drill 4 mm diameter holes at the points you just marked.
➤ Deburr all drill holes and apply rust-protection.
➤ Stick the double-sided adhesive insulation (fig. 8 5, page 5) to the
assembly side of the bracket.
The insulation plate serves as a seal and protects the paint.
➤ Screw the camera bracket on with the 5 x 20 mm self-tapping screws.
38
PerfectView CAM44
EN

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Perfectview cam 44

Table des Matières