Dometic Waeco PerfectView CAM44 Instructions De Montage Et De Service page 39

PerfectView CAM44
If you would like to attach the camera with threaded screws fitted
through the construction (fig. g, page 7)
A
NOTICE!
When tightening the nuts, make sure that they cannot be pulled
through the construction.
You may have to use bigger washers or plates.
➤ Drill 5.5 mm diameter holes at the points you just marked.
➤ Deburr all drill holes and apply rust-protection.
➤ Stick the double-sided adhesive insulation (fig. 8 5, page 5) to the
assembly side of the bracket.
The insulation plate serves as a seal and protects the paint.
➤ Screw the camera holder on with the M5 x 20 mm threaded screws.
Depending on the thickness of the construction, you may require longer
threaded screws.
Creating a through-hole for the camera connection cable (fig. h,
page 8)
I
NOTE
If possible, use available openings – such as ventilation grilles –
to feed the connection cables through. If there are no existing
openings, you must drill a hole with a 16 mm diameter.
A
NOTICE! Risk of damage!
Ensure that there is sufficient space on the other side for the drill
head to come out
➤ Drill a hole of Ø 16 mm near the camera.
➤ Deburr all drill holes that have been made in the sheet metal and apply
rust-protection.
➤ Place cable sleeves in all sharp-edged ducts.
EN
Fitting the camera
39