Lubricating The Cocks Periodically; Knobs; Problems And Suggestions; Installation Premises - BORETTI BGR-88 Notice D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Attention: Check the condition of the flexible
gas pipe periodically and change it whenever
you notice it is deteriorating. It is advisable to
check it at least once a year. It must only be
changed by qualified personnel.
Warnings
– If the burner flame goes out accidentally,
close the knob and do not attempt to light it
again for at least 1 minute.
– When gas cooking appliances are used they
produce heat and humidity in the room in
which they are installed. Please ensure good
aeration in the room keeping the natural ven-
tilation vents free and open or install a suc-
tion hood with discharge duct.
– An intensive and prolonged use of the appli-
ance might need additional aeration like, for
instance, the opening of a window or a more
effective aeration, increasing mechanical
suction power if it exists.

Lubricating the cocks periodically

This must be done by qualified personnel whom
you must contact also if the appliance is mal-
functioning.
It is however advisable each time work is done
on the cocks, to change the cocks and gasket.

Knobs

– The gas hob burner knobs are ONLY TO BE
REMOVED for servicing (regulating the mini-
mum flame) and NOT for cleaning.
– They are to be replaced in the correct order
and in their original position. Any changes
will result in the appliance malfunctioning.
46
Problems and
suggestions
Problem
The gas flow seems
irregular
Smell of gas in the room
If the problems persist or cannot be reme-
died with the above suggestions, contact the
nearest Assistance Centre explaining the
problem found, the model, the item and serial
number of the appliance written on the guaran-
tee certificate.
Attention
This appliances can be installed and used only
on permanently ventilated premises in accor-
dance with the standards.

Installation premises

To ensure the gas-run appliance works proper-
ly the room in which it is installed must have
enough air for the combustion gas, in compli-
ance with the current standards. Vents with
a minimum section of at least 100 cm², must
be made so they cannot be obstructed either
from indoors or outdoors and located close to
the floor; any other type of ventilation must
necessarily comply with the contents of the
standard.

Fumes discharge

Gas-run appliances must discharge the pro-
ducts of combustion directly outdoors through
Suggestions
– Check that the gas cock
is open.
– Clean the holes of the
flame breaker and the
nozzle.
– Check the position of the
burner.
– Check the knobs are in
the OFF position
– Check the condition of
the feeding pipe and its
connections.

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Bgr-116

Table des Matières