Electrical Connection; Connecting Gas; Connecting Appliance - BORETTI BGR-88 Notice D'emploi

Electrical connection

Before connecting to the electricity mains first
check that:
– the electrical supply system is fitted with an
effective earth connection; to the contrary it
must be done separately and in compliance
with current EEC standards;
– The socket or four-pole connecting switch are
easy to reach once the appliance is installed.
The hob is supplied with lead on which a
standardised plug must be fitted that will wit-
hstand the load indicated on the appliance's ra-
ting plate; the plug must then be plugged into
a suitable socket (Fig. 2). In all cases you must
take the precaution to position the lead so that
it will never exceed a temperature that is 50°C
higher than environmental temperature at any
one point.
The manufacturer declines all responsibility if
these accident prevention rules and regulations
are not abided by.

Connecting gas

– Ensure that it has been adjusted to local fuel
types.
– If it is to be fuelled by liquid gas, only a cer-
tified and approved pressure regulator is to
be used.
– Connect the appliance to gas cylinder or
other gas supply in accordance with local co-
des and regulations.

Connecting appliance

– The hob can be installed with either an ap-
proved stainless steel flexible pipe or a rigid
pipe.
– Connection is made to the GJ1/2" threaded
elbow.
– The gasket has to guarantee the connection
holds fast.
– The elbow can be turned by releasing the nut.
Once the desired position has been establis-
hed it is to be tightened again.
Nut
Fig. 3
Fiting for metal pipe
Important: After the installation check there
are no leaks by using a soap solution and never
a flame.
Boretti declines every responsibility if these
safety standards are not respected.
Shaft pipe
Gasket
NL
FR
ES
EN
43