Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
Timer Settings
Example for 6 hours filter lime:
Switch on the pump, if the indication
light isn't red. Press the timer, until the
LED "6" turns red.
Press the ON/OFF button to start the
pump, then the 6H interval will start.
From this point the filter pump runs
for 6 hours non-stop. For example: If
you press the ON/OFF button in this
example by 12:15, then the filtration
system is running until 18:15. The next
day at 12:15, it will start again.
Initial start with external filter
control
If the operation is not required with
the included switch, proceed as
follows. Make sure that the battery
is fully functional in the timer. Then
adjust clock for 24 hours continuous
operation. Now, an external timer-
clock can be preceded and set
arbitrarily (or several inputs and
turn-off times are now possible).
6. STARTING
Once the filter system has been
properly
assembled,
chamber filled with sand and the
hoses connected as described above,
you may begin with filtration. However,
we recommend that you clean and
prepare the new sand that is in the
sand chamber first. Cleaning the sand
prior to filtering your pool will remove
most of the dus! and tiny sand particles
that may exist in the sand. If you move
straight to filtering, these particles will
end up in your pool. To clean the sand,
please follow the instructions below.
Do not plug the system in until advised
to do so below.
1) Make certain the pump is not
plugged in to a power supply.
2) Start with the valve in the 5 Closed
position.
3) If you haven't done so already, fill
your pool with water. Ensure that the
water level is al least 2,5 - 5 cm above
the top of the hose intake (Skimmer)
and return ports in the pool.
4) Release the shut off valve al the
intake port (Skimmer) in the allow the
water to flow into the intake hose.
5) With the filter-pump system installed
in a location level lower than your pool's
water level - water will automatically
flow into the pump-filter system.
6) Allow the filter tank to fill with water.
7) Check for leaks and make any
necessary adjustments. Be cause
of tolerances (in consequence of the
production process), it is possible
that it may be necessary to use a
Teflon tape additionally which has to
be wrapped around the connections,
the
sand
before the connection tube is fixed, in
order to correct these tolerances.
8) Follow the backwash process
described below.
Backwash Process
Disconnect the Motor/Pump from
the Power Source.
Attach backwash hose (not included)
to backwash port.
Publicité
Table des Matières
