Sabo 102-13G Mode D'emploi page 82

HOW TO USE THE MACHINE
WARNING!
!
( ☛ 4.32) to prevent sudden engagement from causing tipping up and
loss of control of the vehicle, particularly on slopes.
5.4.3 B
RAKING
First, reduce the machine's speed by reducing the engine's r.p.m. and then push
the brake pedal (☛ 4.21 or 4.31) to further reduce the speed until the machine
stops.
➤
For hydrostatic drive models:
NOTE
releasing the drive pedal.
5.4.4 R
EVERSE
Reverse must be engaged ONLY when the machine is stopped.
➤
For mechanical drive models:
Push down the pedal until the machine stops and then insert reverse by
moving the lever sideways and putting it into position «R». (☛ 4.22). Gradually
release the pedal to engage the clutch and then begin moving in reverse.
➤
For hydrostatic drive models:
When the machine is stopped, start the reverse movement by putting the
speed change lever in the «R» direction (☛ 4.32).
5.4.5 G
RASS CUTTING
When you have reached the area to be mowed, make sure that the grass-catcher
or stone-guard is correctly fitted and that the cutting deck anti-scalp wheels are
positioned at the required height.
Each anti-scalp wheel can be fitted at two different heights: the low position
always leaves a space between the ground and the edge of the cutting deck to
prevent the deck from damaging the lawn if the ground is uneven. The higher
Drive must be engaged in the way already described
The machine already slows down considerably by just
ENG 27