Sabo 102-13G Mode D'emploi page 100

MAINTENANCE
Access for making this adjustment is by taking off the inspection hatch beneath
the seat.
Loosen the locking nuts (2) and tighten or loosen the screw (1) as much as
necessary for a length "A" of the spring (3) of:
A = 114 - 116 mm (
A = 109 - 111 mm (
measured to the outside of the end of the
spring. When the adjustment has been made,
tighten the nuts (2).
NOTE
take great care when using for the first few
times as engagement may be sudden until
the belt is sufficiently run in.
6.3.6 A
DJUSTMENT OF THE SPRING OF THE PAWL FOR HOOKING THE GRASS
If the grass-catcher tends to jump about and to
open up when going over rough ground, or if it has
difficulty in hooking back on after being emptied,
the tension of the spring will need to be adju-
sted(1).
Change the hooking point by using one of the holes
(2) until the required result is achieved.
➤
For mechanical drive models)
➤
For hydrostatic drive models)
When replacing the belt,
A
3
2
1
1
ENG 45
-
CATCHER
2