Sabo 102-13G Mode D'emploi page 66

UNPACKING AND ASSEMBLY
IMPORTANT
in the battery's manual ( ☛ 6.2.5).
IMPORTANT
ting in, never start the engine until the battery is fully charged!
WARNING!
!
safe handling and disposal.
3.5 FITTING THE GRASS-CATCHER
BRACKETS
Fit the two brackets (1) on the rear plate
(2), using for each bracket three screws
(3) which are supplied, as shown, without
fully tightening the nuts (4).
Hook the upper part of the grass-catcher
frame (5) onto the brackets and centre it
up with the rear plate (2).
Adjust the position of the two brackets (1)
to the stop (6) so that, when turning the
grass-catcher frame, the pin (7) slots into
the seat (8) correctly.
Check again that the frame (5) is properly
centred with the rear plate (2) and that it
rotates correctly, as shown above, and
then fully tighten the screws (3) and the
nuts (4).
Always fully charge the battery according to the instructions
To prevent the safety device in the electronics card from cut-
Follow the battery manufacturer's instructions regarding
3
1
6
1
ENG 11
4
2
5
1
2
8
7 5