Sabo 102-13G Mode D'emploi page 65

ENG 10 UNPACKING AND ASSEMBLY
Line up the hole in the steering wheel hub with the hole of the shaft, insert the
nut (4) into its seat, insert the screw (3) and fully tighten.
3.3 FITTING THE SEAT
Raise the adjustment lever (3) and fit the
4
seat (1) in the slide (2), introducing it from
the steering wheel's side, till the seat
engages in one of the 6 positions.
At this point the seat is engaged and can-
2 1 3
not be completely removed unless the
lever (4) is pressed, freeing it from its
retainer
2
3.4 CONNECTING THE BATTERY
4
The battery (1) is situated under the seat
and is held in place by a spring (2).
Connect the red cable (3) to the positive
terminal (+) and the black cable (4) to the
negative terminal (–) using the supplied
3
screws and following the illustrated
sequence. 1