Tools Required; Mounting Steps - Hella Micro DE Instructions De Montage

10
Accessories, see Fig. page 6
(not included with kit)
Attachment dimensions:
For upright/pendant mounting.
Lamps should neither vibrate nor
extend higher than the bonnet and
must be fi tted symmetrically.

Tools required:

Mounting steps:

1. Adjusting frame
D
C
• Ruler
• Combination pliers
• 10 mm open-end or box wrench
1. Determine mounting position
and mark mounting points accor-
ding to attachment dimensions
given above.
2. Drill pilot hole with 3 mm dia.
bit and then bore out to 8 mm.
Protect drilled metal parts with rust
protection paint.
2. Wiring harness with relay
The table shows the possibilities
permitted in the various countries:
C
• Drill with 3, 8, 12 mm dia. bits
• Screwdriver for recessed-head
3. Remove lamp set, press rubber
grommet in from inside and install
stabilization ring (Fig.1; 2).
4. Preinstall bracket and tighten
bolts hand-tight.
(also see
"One more tip")
screws