Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
To clean your product only use a warm moist cloth and a soft brush.
Never use cleaning agents or solvents. Otherwise the device may be damaged irreversibly. Plastic parts may be corroded by chemi-
cals.
− Do not clean the machine with running water or high-pressure cleaners.
− After each operation treat bare metal parts with an environment-compatible biodegradable spray oil to protect them against corro-
−
sion.
O
p
e
r
a
t
i
o
n
a
l
f
a
u
l
O
p
e
r
a
t
i
o
n
a
l
f
a
u
l
Before each fault elimination:
− Switch off device.
− Wait for standstill of the garden shredder.
−
Pull out mains plug.
Fault
Motor does not start.
Motor hums,
but does not start.
Reduced cutting perform-
ance.
Device starts but blocks
under slight load and cuts off
via protective motor switch.
G
u
a
r
a
n
t
e
e
G
u
a
r
a
n
t
e
e
Please observe the enclosed terms of guarantee.
14
t
s
t
s
Possible cause
− No power supply.
− Mains cable defective.
− Upper part of the enclosure not properly
closed (safety shut-off is activated).
− Cutters blocked.
− Capacitor faulty.
Knife edges became blunt.
Extension cable too long, or cross-section
too small. Socket too far from mains sup-
ply and cross-section of mains cable too
small.
Removal
− Check fuses.
− Have these checked (electrician).
− Close and bolt down upper part of the enclosure cor-
rectly, remove any dirt present.
− Switch machine off, disconnect mains plug, and clean
interior of machine.
− Have machine repaired by manufacturer or approved
company.
Turn the knife or replace it with a new set of knives.
Extension cable at least 1.5 mm², maximum 25 m long. If a
longer cable is used, minimum cross-section 2.5 mm².
Publicité
Chapitres
Table des Matières
