Maintenance Tips; Safety Cut Out; Power Supply - Hendi 211069 Mode D'emploi

5. MAINTENANCE TIPS

• Always pull the plug from the wall socket before
cleaning the urn.
• If the urn is subjected to heavy use, you will need
to de-scale it at regular intervals.
• Never immerse the urn in water or other liquid
cleaning products.

6. SAFETY CUT OUT

EN
Pict. 3. "Reset" buton – boil dry protection system.

7. POWER SUPPLY

• If the unit uses a mains supply, ensure that the
plug is securely inserted into the mains socket
and it is easily accessible.
• Protect the power lead from sharp objects, ex-
cessive heat and damp or wet locations.
• Check the power lead periodically, and replace if
damaged.
6
switch
L
N
E
manual thermostat
• Clean the urn with a damp cloth.
• Never use abrasive or caustic cleaning products.
• Always ensure the electrical connections remain
absolutely dry.
• When you drain off dirty water, leave the tap open
and rinse the urn with clean water.
Urns feature a boil dry protection system, which
will switch off the element if the water level is
too low. To reset the safety cut out, switch off and
unplug the urn and allow it to cool. Empty out the
water and press the RESET button underneath the
urn. Refi ll with cold water and switch the urn back
on again. The urn will automatically reboil.
• Any repairs should only be carried out by a ful-
ly qualifi ed electrician or an authorized service
agent.
• If the supply cord is damaged, it must be replaced
by the manufacturer, its service agent or similar-
ly qualifi ed persons in order to avoid a hazard.
adjustable thermostat
keep warm lamp
heating lamp
thermal link
heater