Heiniger 12V-S Mode D'emploi page 26

BA Schaf S12 englisch:BA Schaf S12 englisch
Motor Section
MALFUNCTION
Motor does not run
Motor runs very slowly
Running time of a charged
batterie ist too short and/or
motor gets hot
Instruction manual S12
8.12.2009
CAUSE
Storage battery empty
Terminal clamps are loose
(Illustration 1, Item 19)
Smell of burning from the
motor housing. Motor burned
out
Switch without contact
Machine jams because of
wrongly or reverse connected
terminal clamps
Storage battery empty
Wrong type of storage battery
Shearing tension too high
and/or shearing blades are
blunt
Blades and shearing head
were inadequately oiled
Air filter blocked
Flat, wrong or too small
storage battery being used
Faulty storage battery
8:51 Uhr Seite 13
RECTIFICATION
Charge storage battery
Switch off machine (Switch to
0) and secure terminal clamps
Have motor replaced
Have switch replaced
Have machine repaired by
specialist workshop
Charge storage battery
Only use 12V lead storage
batteries with a min. of 45 Ah
Reduce shearing tension
(Illustration 6)
Have blades resharpened
Oil blades and shearing head
(Illustration 4)
Clean or replace air filter
Use fully charged, 12V lead
storage battery with a min. of
45 Ah
Replace storage battery
13