Configuration - Panasonic VL-SWD501EX Mode D'emploi

Function name
Motion detection range
Recording before
detection
Check sensors
Recording test
External sensor
*1 When [Day and night switch] is set to [Timer], the configured time periods are displayed above the [Night only]
and [Day only] setting buttons.
Item name: Screen settings
Function name
Brightness
Backlight compensation
Automatic illumination
Uneven colour
prevention
Item name: Sound settings
Function name
Sensor trigger sound
Setting contents and other information
R Select the range (area) of motion detection.
– By setting the areas that you do not want motion to be detected in to X, you can
narrow down the areas that motion can be detected in.

Configuration

1. Touch areas that you do not want motion to be detected in so
that X is displayed on those areas. (Touch again to remove
X.)
2. Touch [Configure].
<1 second before>, 2 seconds before
R Select to start recording 1 or 2 seconds before a sensor detection is made.
See page 23 for information about recording intervals and sensor detection
recordings.
Heat sensor, Motion detection, External sensor
R You can check the operations of each sensor when setting the camera, or at any
other time.
– Select the type of sensor that you want to check, trigger it, and then confirm if
detections were correctly made. (See the Installation Guide for the camera for
information about how to check the sensors.)
R Confirm if images are correctly recorded before and after images are recorded for
sensor detections. (See the Installation Guide for the camera for more information.)
<Make contact>, Break contact
R When using commercially available external sensors, select the type of contact
points used by the sensor.
– Select the type of contact point according to the external sensor used and its
function.
Setting contents and other information
-3, -2, -1, <0>, +1, +2, +3
R Adjust the brightness of camera images. (The higher you set the brightness, the
brighter the image.)
– Make adjustments when the images are very dark or bright.
On, <Off>
R When [On] is selected, backlight compensation is performed. However, depending
on the background of the subject, the backlight compensation may not be effective.
When the sensor is triggered: Enable, <Only when dark>, Disable
When monitoring: Enable, <Only when dark>, Disable
On, <Off>
R Normally use this setting set to [Off]. Only set this setting to [On] if the colour in
camera images is uneven. (When set to [On], the image quality may be reduced
when it is dark.)
Setting contents and other information
Sound type: <Sound a>, Sound b, Sound c
Volume: <Loud>, Normal, Quiet, Mute
R Select the type and volume of the sound to be made by the camera when there is
a sensor detection.
6. Using a camera
27