Storage; Cleaning And Maintenance; Safety Information - CASO DESIGN VRH 490 advanced Mode D'emploi Original

Connect one end of vacuum hose at the connector at device and other end at connector at
canister cover or with the adapter at canister cover.
Press button for canisters (Vakuum Behälter).
To ensure there is no air leaking between the cover and the canister, use your hand to
push down the cover at the beginning of the vacuum operation. The device will stop
automatically when enough vacuum pressure is achieved.
Alternatively you can press button pulse vacuum (Manuelles Vakuum) to adjust the
vacuum strength by yourself and stop at desired point of time.
Remove the vacuum hose from the cover of container first then from the connector at
device. You can cancel the operation at any time by pressing button Vacuum & Seal /
Cancel (Vakuum & Schweißen/Abbrechen).

17.7 Storage

Store the device in its upright position, out of the reach of children.
► Always unplug the appliance from its outlet immediately after using and before
cleaning.
► For the correct storage, please slightly close the cover, do not lock, it will deform the
gaskets and affect the machine function.

18 Cleaning and Maintenance

This chapter provides important information on properly cleaning and maintaining your
vacuum sealer.

18.1 Safety information

Attention
Please observe the following safety notices, before cleaning the unit to avoid
damage to the unit or personal injury:
► Unplug the device prior to cleaning it.
► To ensure optimum performance, the unit must be cleaned regularly. Failure to clean
the unit regularly can lead to potential malfunctions, as well as safety and health risks.
► The sealing bar remains hot after use. Wait a few minutes until the strip has cooled
before cleaning.
► Clean the unit after every use as soon as it has cooled. Leaving the unit uncleaned for
long periods can make it very difficult to remove leftover food and grime and may even
damage the unit.
► If moisture penetrates the unit's housing, it can damage the electronic components.
Please ensure that no moisture enters the device.
► Do not use any harsh or abrasive cleaning agents.
► Do not attempt to scrape off stubborn grime with hard or abrasive tools.
► Dry all parts thoroughly before using after cleaning.
► Never immerse the device in water or other liquids and do not place in the dishwasher.
PLEASE NOTE
41