Instruction For Use - Hendi 210864 Mode D'emploi

5. INSTRUCTION FOR USE

5.1. ASSEMBLING
• Due to unintended starting up of the KS100E
• Place grinder/feeder head tightly into attachment
opening (fi g.1). Holding head with one hand, place
locking knob into the hole on the side of the mo-
tor housing and tighten knob by turning clockwise
(fi g.2).
• Place the snake into the head, long end fi rst, and
turn to feed the screw slightly until it is set into the
motor housing (fi g.3).
• Place the cutting blade onto the snake shaft with
the blade facing the front as illustrated (fi g.4). If
it is not fi tted properly, meat will not be grinded.
EN
6
• Place the desired cutting plate next to the cutting
blade, fi tting protrusions in the slot (fi g.5).
• Support or press the centre of the cutting plate
with one fi nger then screw the fi xing ring tight with
another hand (fi g.6). Do not over tighten.
• Place the hopper plate on the head and fi x it into
position.
• Locate the unit on a fi rm place.
• The air passage at the bottom and the side of
the motor housing should be kept free and not
blocked.