General Information - Hilti TE 6-A Mode D'emploi

ORIGINAL OPERATING INSTRUCTIONS
TE 6-A/TE 6-A Li cordless rotary hammer
It is essential that the operating
instructions are read before the
tool is operated for the first time.
Always keep these operating
instructions together with the tool.
Ensure that the operating instruc-
tions are with the tool when it is
given to other persons.
Operating controls
Chuck
Side handle with depth gauge
Selector switch for hammering action / rotary only
Forwards / reverse switch and transport lock
Control switch
Battery (accessory, not supplied with the tool)
Release buttons with additional function - activation
of charge status indicator (only TE 6-A Li)
Charge status and fault indicator (only TE 6-A Li)
Belt adaptor (accessory, not supplied with the tool)
Contents

General information

Description
Technical data
Safety rules
Before use
Operation
Insert tools and accessories
Care and maintenance
Manufacturer's warranty - tools
Disposal
EC declaration of conformity
General information
1. Signal words and their meaning
-CAUTION-
Used to draw attention to a potentially dangerous situa-
tion which could lead to minor personal injury or dam-
age to the equipment or other property.
Printed: 07.07.2013 | Doc-Nr: PUB / 5071061 / 000 / 00
-NOTE-
Used to draw attention to an instruction or other useful
information.
2. Pictograms
Warning signs
General
Warning:
warning
electricity
Symbols
V
---
- - -
n
o
/min
Return
waste material
for recycling
The numbers refer to the illustrations. The illustra-
tions can be found on the fold-out cover pages. Keep
these pages open while you read the operating instruc-
tions.
In these operating instructions, the TE 6-A/TE 6-A Li with
battery is referred to as "the tool".
Location of identification data on the tool
The type designation can be found on the type identifi-
cation plate and the serial number on the side of the motor
housing. Make a note of this data in your operating instruc-
Page
tions and always refer to it when making an enquiry to
11
your Hilti representative or service department.
11
The TE 6-A carries the generation designation 01 after
the tool designation TE6-A on the type identification plate.
12
The TE6-A Li carries the generation designation 02 after
13
the tool designation TE 6-A Li on the type identification
16
plate.
16
Type:
17
18
Generation:
19
Serial No.:
19
19
Description
The TE 6-A / TE 6-A Li is a cordless, battery-powered,
rotary hammer drill with pneumatic hammering mech-
anism designed for professional use.
The following conditions must always be observed
when the tool is in use:
- The tool is for hand-held use only.
- Do not use the tool in places where the surrounding
conditions may present a risk of explosion.
Symbols
Warning:
caustic
substances instructions
before use
= volts
= direct current
= no load speed
= revolutions per minute
= hammer drilling
= rotation only
en
Read the
operating
11