General Information; Safety Notices And Their Meaning; Description - Hilti DD 130 Mode D'emploi

1. General information

1.1 Safety notices and their meaning

-DANGER-
Draws attention to imminent danger that will lead to seri-
ous bodily injury or fatality.
-WARNING-
Draws attention to a potentially dangerous situation that
could lead to serious personal injury or fatality.
-CAUTION-
Draws attention to a potentially dangerous situation that
could lead to slight personal injury or damage to the
equipment or other property.
-NOTE-
Draws attention to an instruction or other useful infor-
mation.
1.2 Pictograms
Warning signs
General Warning: Warning: hot
warning electricity surface
Obligation signs
Wear eye Wear a safety Wear ear
protection helmet protection
Symbols
Read the operating
instructions before use.
A V
Amps Volts
~
rpm
Revolutions Alternating Nominal
per minute current speed under
no load
16
Printed: 08.07.2013 | Doc-Nr: PUB / 5069520 / 000 / 01
Wear safety Wear safety
gloves boots
Return waste material
for recycling.
W Hz
/min
Watts Hertz Revolutions
per minute
∅ ∅
n
o
Diameter
On the drill stand
VACUUM
VACUUM
Top
An additional means of secur-
ing the drill stand must be
employed when used for hori-
zontal drilling with vacuum
attachment.
Bottom
The drill stand must be fas-
tened by means of an anchor
or quick-release brace when
used for overhead drilling.
These numbers refer to the corresponding illustra-
tions. The illustrations can be found on the fold-out cov-
er pages. Keep these pages open while studying the
operating instructions.
In these operating instructions, the DD 130 core drilling
machine is referred to as "the tool".
Location of identification data on the tool
The type designation and serial number can be found
on the rating plate on the tool. Make a note of this data
in your operating instructions and always refer to it when
making an enquiry to your Hilti representative or ser-
vice department.
Type:
Serial no.:

2. Description

The DD 130 is an electrically powered diamond core
drilling machine designed for hand-held use or for mount-
ing on a drill stand. It is suitable for wet or dry core
drilling.
Use as intended
The DD 130 is designed for drilling through holes and
blind holes in mineral materials.
On the tool
Use of the water collector
system in conjunction with a
wet-type vacuum cleaner is
mandatory when working
overhead on ceilings.
DD130