EHEIM streamonON+ 3500 Mode D'emploi page 28

English
2. Pull the impeller j out of the motor housing.
3. Gently press the power controller f apart and remove it from the
pump basket.
4. Using a brush, clean all components under running water. Remove lime
scale deposits with 10 % citric acid
5. Install the pump again in reverse order.
When assembling, make sure that the washer disc i is correctly inserted
into the motor housing.
streamON+ 6500 / 9500 (⌦G)
1. Press both latches simultaneously and remove the pump basket h
from the motor housing.
2. Pull the power controller g out of the motor housing.
3. Pull the impeller j out of the motor housing.
4. Using a brush, clean all components under running water. Remove lime
scale deposits with 10 % citric acid
5. Install the pump again in reverse order.
When assembling, make sure that the bearing bushings k are inserted
correctly in the pump basket and in the motor housing.
7. Clearing faults
Attention! Electrocution!
▶ Before clearing faults, remove the mains plug of the pump.
Faults
Pump does not start
Pump does not pump
Possible cause
No mains voltage
Mains plug is not inserted
Impeller is blocked
28
Remedy
▶ Check the mains
voltage
▶ Check the supply line
▶ Insert the mains plug in
the mains socket
▶ Clean the pump