Zanussi ZRT623W Notice D'utilisation page 11

•• It is dangerous to alter the specifications or modify this
product in any way. Any damage to the cord may cause
a short-circuit, fire and/or electric shock.
Warning! Any electrical component (power cord,
plug, compressor) must be replaced by a certified
service agent or qualified service personnel.
1. Power cord must not be lengthened.
2. Make sure that the power plug is not squashed or
damaged by the back of the appliance. A squashed
or damaged power plug may overheat and cause
a fire.
3. Make sure that you can come to the mains plug of
the appliance.
4. Do not pull the mains cable.
5. If the power plug socket is loose, do not insert the
power plug. There is a risk of electric shock or fire.
6. You must not operate the appliance without the
4)
lamp cover of interior lighting.
•• This appliance is heavy. Care should be taken when
moving it.
•• Do not remove nor touch items from the freezer com-
partment if your hands are damp/wet, as this could
cause skin abrasions or frost/freezer burns.
•• Avoid prolonged exposure of the appliance to direct
sunlight.
Daily Use
•• Do not put hot pot on the plastic parts in the appliance.
•• Do not store flammable gas and liquid in the appliance,
because they may explode.
•• Do not place food products directly against the air
outlet on the rear wall.
•• Frozen food must not be re-frozen once it has been
thawed out.
•• Store pre-packed frozen food in accordance with the
frozen food manufacturer's instructions.
•• Appliance's manufacturers storage recommendations
should be strictly adhered to.
•• Do not place carbonated or fizzy drinks in the freezer
compartment as it creates pressure on the container,
which may cause it to explode, resulting in damage to
the appliance.
4) If the lamp cover is foreseen
5) If the appliance is Frost Free
6) If a water connection is foreseen
5)
•• Ice lollies can cause frost burns if consumed straight
from the appliance.
Care and cleaning
•• Before maintenance, switch off the appliance and dis-
connect the mains plug from the mains socket.
•• Before using the appliance for the first time, wash the
interior and all internal accessories with lukewarm wa-
ter and some neutral soap so as to remove the typical
smell of a brand-new product, then dry thoroughly.
•• Do not clean the appliance with metal objects.
•• Do not use sharp objects to remove frost from the ap-
pliance. Use a plastic scraper.
•• Never use a hair drier or other heating appliances to
speed up defrosting. Excessive heat may damage the
plastic interior, and humidity could enter the electric
system making it live.
•• Regularly examine the drain in the refrigerator for de-
frosted water. If necessary, clean the drain. If the drain
is blocked, water will collect in the bottom of the ap-
pliance.
Installation
Important! For electrical connection carefully follow the
instructions given in specific paragraphs.
•• Unpack the appliance and check if there are damages
on it. Do not connect the appliance if it is damaged.
Report possible damages immediately to the place you
bought it. In that case retain packing.
•• It is advisable to wait at least four hours before con-
necting the appliance to allow the oil to flow back in
the compressor.
•• Adequate air circulation should be around the appli-
ance, lacking this leads to overheating. To achieve
sufficient ventilation follow the instructions relevant to
installation.
•• Wherever possible the back of the product should be
against a wall to avoid touching or catching warm parts
(compressor, condenser) to prevent possible burn.
•• The appliance must not be located close to radiators
or cookers.
•• Make sure that the mains plug is accessible after the
installation of the appliance.
•• Connect to potable water supply only.
6)
11