Boost Start Rpm (Stock Firmware Only); Boost Timing Acceleration (Stock Firmware Only); Turbo Timing - Team Orion Vortex R10.1 Pro Mode D'emploi

dynamically in relation to the motor RPM). With the stock
firmware you can adjust higher value than with the modified
software, resulting in higher performance.
› Setting range:
modified from 0° to 16° in 1° steps
stock from 0° to 64° in 1° steps

11. Boost Start RPM (stock firmware only)

This setting sets the motor RPM at which the boost timing
activates. For example if you set the boost start at 5000RPM,
the boost timing will be 0deg until 5000RPM and then will be
applied in relation to the boost timing acceleration setting.
Using a lower value will improve the low RPM performance.
› Setting range:
from 1000 to 15000RPM in 1000RPM steps

12. Boost Timing Acceleration (stock firmware only)

This setting adjusts the rate at which the boost timing is
applied. 1° of boost timing is added every set amount of
RPM. For example if you set the value to 500RPM with
a boost timing of 20deg and a boost start 5000RPM, it
means that the motor will have to reach 15000RPM before
the full 20deg of boost timing is applied (20x500RPM +
5000RPM start). Using a lower value will give you a stronger
acceleration.
› Setting range:
from 50 to 750RPM in 50RPM steps

13. Turbo Timing

This is a secondary timing which is added onto the boost
timing, but only at full throttle (down the straight for
20 Copyright Team Orion © 2014