Putting The Device Into Operation - Geberit AQUACLEAN Mera Classic Instructions De Montage

EN
Adjusting basic settings
to customer's wishes
Classic model
The basic settings of the device are set
from the rear of the remote control.
The following steps are shown in shortened
form. See user manual for an overview of
the complete menu.
Prerequisite
– The function test of the device was performed
successfully.
– The testing of the remote control was performed
successfully.
1
Call up the [Basic setting] main menu via the
<left>/<right> arrow key.
Basic settings
Select submenus with the <up> and <down>
arrow keys. Configure settings with the
<left> and <right> arrow keys.
2
Call up the [Select language] menu. Set the
menu language.
3
Call up the [Water hardness] menu. Set the
hardness value in accordance with the local
water hardness.
Range
soft
medium
hard
Set to [hard] if you do not know the local
water hardness.
54
Select language
English
Water hardness
hard
4
Call up the [Basic settings] menu.
Basic settings
Result
✓ The settings are saved.
✓ The device is installed correctly.
Commissioning

Putting the device into operation

Prerequisite
– Function test using the lateral control panel was
performed successfully.
– Function test of the remote control was
performed successfully.
– The device is installed correctly.
1
Remove the spray shield.
2
Clean the device.
3
Close the WC seat and WC lid.
Result
✓ The device is ready for operation and can be
handed over to the customer.
9007203612975499-1 © 11-2018
968.543.00.0 (00)