Installation; General Considerations; Installation Configurations A70 Ac70 - Palazzetti INSERIMENTI A70 Manuel D'installation

7

INSTALLATION

7.1

General considerations

In the following paragraphs some indications
are provided to be respected in order to obtain
the maximum performance from the purchased
product.
The following indications are how-
ever subject to compliance with any
possible national, regional and mu-
nicipal laws and regulations in force
in the country where the appliance is
installed.
7.2 Installation configurations
A70 AC70
It is possible to install the appliance:
• with front air distribution
• channelled onto the top of a fireplace with or
without optional frame.
7.2.1 Generator installation on the floor of a
fireplace
In the event of installation in structures with
marble cladding or other materials, the insert
has sliding guides to assist with extracting the
equipment for attaching to the fixing surface
and for carrying out inspections and checks on
the mechanical and electrical components.
Positioning the generator without pedestal
• Once the pallet has been removed (refer to par-
agraph: "HANDLING AND TRANSPORTATION")
proceed as follows:
• Rest the base on the floor of the chimney (1),
trace and make 4 holes (diameter 6) for fixing
(2) - use the base itself as a template - then drill
the holes with a bit with a diameter of 6 mm.
• Insert 6 mm dowels in the drilled holes and fix the
base with the screws.
2
Ø 6mm x 4
1
Insert dowels
66
3
Ø 6mm x 4
1
Fig. 23
• Reposition the machine in the sliding guides
• Re-assemble the fixing bolts removed previ-
ously
• Re-connect the display cable connector, with
its relative mass, to the board and the power
cable.
• Push the machine to the end position of the
guides, paying attention to any interference
caused by the cables. Then group these cables
together through the application of a tie
Fig. 24
Fig. 25
Fig. 26
004778740 - 14/06/2021