Ordinary Maintenance; Cleaning The Inside Of The Firebox; Cleaning The Glass - Palazzetti INSERIMENTI A70 Manuel D'installation

9.4 Ordinary maintenance

9.4.1 Cleaning the inside of the firebox

Daily or before each ignition, it is necessary to
check that the burn pot is clean to ensure the
free flow of combustion air from the holes of the
burn pot itself.
Vacuum the ash accumulated in the burn pot
(Fig. 42).
ATTENTION: remove the ash from the
combustion chamber because the salts
present cause corrosion of the metal. In
addition, the ash could block the pas-
sage of air, varying the development of
the flame which, if it approaches the
glass, would increase corrosion.
After cleaning the burn pot, remove it from its
seat and clean the compartment that contains it
including the resistor (Fig. 43).
004778740 - 14/06/2021
ITALIANO ENGLISH
Fig. 42
Fig. 43
FRANÇAIS
If necessary, remove the ash grate and empty
it, taking care to clean any residue that may be
contained in the compartment (Fig. 44).
Using an ash vacuum can simplify the
cleaning operations
• Remove the grille (1)
• Remove the drawer (2) to access the vents (3).
• Using an ash vacuum cleaner, clean the pas-
sage of flue gas including the two lower vents.
3
1
Repeating the previous operations in reverse,
reassemble the drawer and the grid.

9.4.2 Cleaning the glass

It is carried out with a damp cloth or with damp-
ened paper that is wiped over the ash.
Rub until the glass is clean.
DEUTSCH ESPAÑOL
Fig. 44
2
Fig. 45
75