Zanussi ZRG15805WA Mode D'emploi page 22

Problem
Water flows on the rear plate
of the refrigerator.
Water flows into the refrigera-
tor.
Water flows on the floor.
Door is misaligned or interferes
with ventilation grill.
The temperature in the appli-
ance is too low/too high.
There is too much condensed
water on the rear wall of the re-
frigerator.
Door does not open easily.
If the advice does not lead to the
desired result, call the nearest
Authorized Service Centre.
22
Possible cause
Temperature is set incorrectly.
During the automatic defrost-
ing process, frost melts on the
rear plate.
The water outlet is clogged.
Food products prevent that
water flows into the water col-
lector.
The melting water outlet is not
connected to the evaporative
tray above the compressor.
The appliance is not levelled.
The temperature regulator is
not set correctly.
The door is not closed correct-
ly.
The food products' tempera-
ture is too high.
Many food products are stored
at the same time.
The thickness of the frost is
greater than 4-5 mm.
The door has been opened of-
ten.
Door was opened too fre-
quently.
Door was not closed com-
pletely.
Stored food was not wrapped.
You attempted to re-open the
door immediately after closing.
Solution
Refer to "Operation" chapter.
This is correct.
Clean the water outlet.
Make sure that food products
do not touch the rear plate.
Attach the melting water outlet
to the evaporative tray.
Refer to "Levelling".
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
Let the food products temper-
ature decrease to room tem-
perature before storage.
Store less food products at the
same time.
Defrost the appliance.
Open the door only if necessa-
ry.
Open the door only when nec-
essary.
Make sure the door is closed
completely.
Wrap food in suitable packag-
ing before storing it in the ap-
pliance.
Wait a few seconds between
closing and re-opening of the
door.